DESCRIPTION: I want to slow things down and add some info when it comes to the harness. These are not huge harnesses but I have not seen anything on manufacturing one. It is simple stuff but I just would like to document harness clips and routing . Their are many different configurations on the harness clips and use. Of course this tractor had a 6volt system, positive ground and a switch that was manually used by the operator to handle the charge rate. My tractor will not be set up that way. It will have a 12 volt gen, voltage regulator and a in line fuse with a 3 postion switch, 1. off 2. dim 3. bright . I am using 10 gauge wires on everything except, headlight wire, tail light wire which is 14ga wire. The load wire (10 gauge wire) which runs power to the switch will be protected by an in line 20 amp fuse. Stay tuned and thanks for watching.