DESCRIPTION:
Here is the YouTube link to the video that shows how to remove the front fascia. If the link does not work, cut and paste in your browser or search YouTube with key words “Cherokee Fascia”.

https://www.youtube.com/watch?v=iIAY4WjOGOg

Parts Required:

Bezels from Jeep/Chrysler
68203220AA (right)
68203221AA (left)

Light Assemblies (Amazon or other)
5182426AA (These are the wrong ones shown in the video. They said they fit multiple Jeeps and a Fiat. They clearly were intended for a Fiat only. Compare with the right number for the Jeep, 5182026AA, and you can see the difference. There are six holes instead of four to align with the alignment pins. Or use some other LED or trick aftermarket lights.) Be aware that light assemblies may come with or without bulbs, and bulbs aren’t cheap.

Wiring Harness (Amazon or other)
Cheap way to get the wire you need complete with a set of the plugs that go with the bulbs. My plugs were called H11 style. (Look on the bulb for this connector code.) You also get a relay and maybe even a switch. Many of these harnesses are for HID headlights which plug into the headlight circuit for sensing. I chose a harness that was NOT specifically for HID headlights. You are on your own to figure out what is best for you.

Switch (Radio Shack or other)
Yes you can still find an open Radio Shack. If you want a lighted switch, make sure it is set up for 12 volts.

Hardware:
The clip-on nuts shown were called speed-nuts. You also obviously need the bolts and washers to go with them. And you will need some plastic fasteners to replace the rivets you drill out to get the fascia off. These are all available at most discount auto parts stores or a good old fashioned hardware store.

Good Luck