How To Tune Drums - by DW's John Good - Video
PUBLISHED:  Aug 31, 2011
DESCRIPTION:
John Good brings you into the DW Assembly Line to show you how he suggests tuning your drums, regardless of the brand.

He tunes 3 different types of drums:
Tom @ 0:40
Snare @ 5:14
Bass Drum @ 10:52

John says it best, but to summarize the key points:

-Always do one head at a time

-Before tightening the tension rods, push hard on the center of the head to "seat/center" the head. You'll hear it crackle, but don't worry, you're not damaging the head. Only breaking it in.

-First use only your fingers to tighten the tension rods, tightening opposing rods so that the head seats flat and even. Similar to how you'd tighten lugs on a car wheel. Alternating in a criss-cross pattern.

-Once all the rods are finger-tight, it's time to use a key. A couple turns on each, still following a criss-cross pattern, is all you should do per round. Each time you complete a full circle, it's good to listen to where you're at.

-Now, each time you complete a round, is when you really do fine tuning. Lightly tap your finger about an inch from the edge of the drum on each rod and listen to hear which rods are higher or lower in pitch from the rest. This is the hardest part, because it takes a very critical ear (that most guitar players don't even have ;). You'll also find that if you come across a rod that is lower than the rest, the one directly across from it is probably also lower. It's good to think of them in pairs.

-Continue making rounds with a couple turns on each rod, followed by a round of fine tuning until you feel the head is at the pitch you desire.

-If you ever feel like you made a mistake or feel like it's just messed up, you can always completely loosen all the rods on that side and start over with the finger-tightening. Practice makes perfect!

-Remember that tuning is very subjective; everybody has a different preference. Many people prefer to tune the bottom head slightly lower than the top so that the note bends down in pitch when you hit it.

-Also, be sure to replace you bottom heads about once every four time you change the top. Many drummers assume that because they don't hit the bottom head, that they can last forever. But indeed they do take a sympathetic beating.

For all things DW, visit http://www.dwdrums.com

To stay up to date with the latest daily info,
"Like" our Fan Page @ http://www.facebook.com/dwdrums

and follow our Tweets too!
http://www.twitter.com/dwdrums
follow us on Twitter      Contact      Privacy Policy      Terms of Service
Copyright © BANDMINE // All Right Reserved
Return to top